B (B), C (D), D (3), E (4), F (5), S (6), F (7), F (9), S (9).
The following content is clearly stated, please be sure to fill out the relevant content table. If this information needs to be further contacted with the news but is not specified, please communicate offline or evaluate it through practical actions such as interaction, product and electricity consistency, and the rationality of workload.
Due to the fact that the above is precisely obtained by P, it cannot be decided by buyers only after modification. The intelligent solutions for the entire industry have not yet been released. Please provide feedback to the designated experts before reviewing the product usage trends!
Special attention: product updates with ultra-thin parts or service output layers marked with standard specifications and absolute standards, and ultra-thin to minimum thickness (approximately feet to 4 mm).
● Special mechanisms must be provided for special needs, such as a guided sliding surface, otherwise it will be deemed unable to meet the requirements. The design requirements are for the same set of parts, and other parts may have flange metric and finished flange metric.
● The supporting parts are equipped with anti break devices for maintenance and repair, and fasteners such as tool pliers and needle nose pliers are used to ensure the stability of processing dimensions.
Handwheel, telescopic arm, lifting screw, expansion sleeve, workbench. Other types of fasteners, etc.
Handle: The handle is used to adjust the vertical position of products and equipment, with a levelness not higher than the base. The base is made of carbon steel using carburized and quenched chrome plating technology, which plays a role in anti slip performance and is better used.
● Handle: The handle is used for fastening, the handle is used to protect or extend the handwheel, and the OUS B is for pressure fitting adjustment, using a suitable method.
Handle: The handle is used to adjust the vertical position of the product or equipment, with a level not higher than the base.
The handle is used to adjust the vertical position of the product and equipment, with a level not higher than the base, and in a suitable way. Adjust the horizontal position of the equipment in a suitable way and make appropriate adjustments on the basis of the handwheel.
Both the handle and the movable handle use movable handles, which can effectively prevent the handle from heating or injuring people, greatly contributing to the protective effect of the machine.
The handle is divided into two types: a handle and a movable handle. The handle structure is diverse, and there are two functions that can be used as a handle: good flexibility, the ability to change the direction of movement, and the ability to transmit motion control force, so it can play a good role as a device.