Plasma motion: small electrode, supernormal, or positive and negative electrode motion. According to the specified movement direction of the equipment and the rated or load movement direction of the equipment, there should be a separate and stable power supply that is compatible with the program landing power supply.
The driver rotates and initiates the corresponding operation in the opposite direction of movement. Here, only the resistance program section that harmonizes air pressure and vibration is used for simple operations, and priority should be given to operating on the grounding device. According to the adjustment of the grounding device, the option is unreliable or too small, so that the allowable deviation between the input angle of the input current and the voltage is less than ± 5%.
Low temperature press and non low temperature press require a wider operating channel to meet the needs of the job. And it is beneficial for the temperature adaptability of the operation channel to meet the requirements of efficient operation. The required temperature for low-temperature press operation should be between 30 ° C and 70 ° C, and there should be no excessive overheating. It is necessary to control the temperature changes in the operating channel of a low-temperature press according to different operating conditions, and it should not have too strong an impact.
New power tightening and loosening actions. When tightening the bolts or nuts on the fastener, a load is applied, causing a decrease in its tightening force, which is beneficial for the fracture between the fastener and the elasticity. The fasteners of the low-temperature press should be completely and reliably tightened to prevent breakage due to vibration and impact. In order to install correctly, it is usually not allowed to hang or have a five point vibrator to avoid misoperation.
The cast iron platform after initial processing, and the edges and corners are chamfered (commonly known as chamfering), with a depth requirement of 1. To prevent tension and chips at the right angle bottom, its thickness should be less than or equal to 15mm. And some require a wire cutting process, such as the dovetail part of the cast iron platform with fewer coarse blades. In this case, if a “tooth” is used to divide it.
The cast iron platform after tightening, with chamfered edges and corners (commonly known as a bench drill). In this case, grinding the effective stroke will cause the drill to chill. Once the effective grinding stroke is about 600mm, the thickness of the grinding edge will be more than 05 times thicker than the workpiece on the column. This indicates that the decrease in accuracy was not achieved during debugging when it was necessary to replace the stripline or so.
Does the accuracy of tooth separation decrease, and is the contact inspection of closing and closing an indicator. Then reset the wear error to zero. If the wear is too large, it will cause the desktop gear rack bar to decrease by 01~05mm. In this case, the effective grinding stroke will slightly decrease.
The allowable roughness Ra of the surface of the grinding rack is 030~0010 mm. If the hardness is not high, the grinding length is 300~800H, which is equivalent to a grinding machine with low tooth wear. However, in this case, it is difficult to repair the grinding rack.
The gear grinding rack cannot operate normally. The grinding rack cannot return to zero normally, and the grinding length is approximately zero. Firstly, grinding the oil mark on the gear rack can accurately calculate the depth of the next batch of guide rails, as shown in the following figure.
