Precautions for fasteners manufacturers: The machine has already been implemented, so it only needs to be turned on again to avoid damage to the fasteners manufacturer.
(1) Before installation, the fasteners should be checked for looseness and damage, and vibration tests and re inspections should be conducted.
(2) Attention should be paid to whether there is space for installing fasteners and carefully check whether there is tension on the fasteners to ensure they are secure.
(3) When it comes to usage issues, it is important to adhere to a certain speed and stop time, as well as air freight transfer time.
(4) For rotating fasteners, avoid vibration and impact, and operate without power supply voltage.
(5) When installing the mold, perform a pressure test to check for any signs of damage or rust.
(6) fasteners manufacturers should strictly follow this batch management procedure when installing and using electric wrenches.
When using electric wrenches by fasteners manufacturers, please strictly follow the management procedures of this batch and cooperate with the use of tools to use a special wrench for assembly and punching inspection of fasteners. If there is looseness, remove the electric wrench and apply it according to the rated instructions.
This training is for the purpose of
1. Operator training, and non professional training is allowed.
2. When starting an electric wrench, it should be operated with no load to avoid injury.
3. When using an electric wrench, first hook the wrench and turn it for two to two seconds, and then test it once with no load. Once it has moved enough, use the required tool.
4. When operating an electric wrench, pay attention to whether the front end is correct.
5. Properly install fasteners, threads, and related parts to avoid damage to the electric wrench.
6. Tighten the push plate to the screw to ensure precise tightening. And move the screw back and forth several times to make it correct and reliable.
7. Operators are not allowed to shovel flowers, electric wrenches have safety belts.
8. There are three operating conditions for an electric trigger
1. Turn on the power and check in advance whether the tool is pointing in line with the specified arrow.
2. Before homework every day, please test whether the pressure of the tools used has a domestic standard product. If there is a standard product during the tool pressure reading, press the crushed screws into the feed port of the electric construction machine.
3. Note that electric wrenches will not shut down due to locking. If it is necessary to remove the electric wrench to confirm its integrity. If the electric wrench is not used, only the cylinder needs to be disassembled.
4. For the operation of the fixed handle, please note that the electric wrench and electric torque label are the same.
5. After confirming the specific reason or confirming that there are no errors, processing operations can only be carried out.
6. It is strictly prohibited to operate the rotation of electric wrenches.
7. After installing the correct device on this machine, it often causes the device to send messages.
8. Only after confirming that there are no errors can the power be turned on.
9. The fixed pins and pins of the drilling machine must not be loosened.
10. After using an electric wrench to rotate for a period of time, check the accuracy of the belt and see if the oil level is abnormal, and then start the equipment to idle for two minutes.
If there is no obvious shaking, make a record when the power is turned on, and then turn on the power switch after confirming that there are no problems until the action is correct.
Leave A Comment